Skip to content

Amsterdam colocation network

Amsterdam network: volume and premium uplinks

Every colocation comes with a port on our volume network, traffic included. Want better connections and lower latency? Choose premium and pay by the traffic you actually use, so you never pay for premium you do not need. Every port runs at full speed and is never oversold.

Yellow and grey patch cables and fibre in a patch panel and switch

Volume or premium: the quality of the uplinks

The two networks differ in the uplinks behind your port, not in how fast your port runs. Premium costs us more per bit, so you pay for it per bit — and only for the traffic that needs it.

Volume network — included

Cost-efficient transit and peering, for backups, storage, downloads, mail and most websites. Devices get 10 TB a month, then €5 per 10 TB. Racks get 20 TB, or commit to a bandwidth at €0.08 per Mbps.

Premium network

More and better connections and lower latency, for traffic where every millisecond counts. Devices pay €2 per TB used. Racks commit to a bandwidth at €0.15 per Mbps; above it, €0.20 per Mbps.

How a commit is measured

The 95th percentile: we measure every 5 minutes, set aside the busiest 5% of the month and bill the highest value that remains. A short peak costs you nothing extra.

Connectivity: ports, traffic, BGP, cross-connects

Every connectivity line with its price. Unmetered 10 Gbps and unmetered premium are on request.

Volume networkPremium network
WhatCost-efficient transit and peeringMore and better upstreams, lower latency
Device: included traffic10 TB per monthnone: you pay per TB you use
Device traffic€5/mo€2/mo
Rack: included traffic20 TB per month, or a commita commit you choose
Rack: extra 10 TB traffic€5/mo—
Rack: commit, per Mbps€0.08/mo€0.15/mo
Rack: above your commit€0.15/mo€0.20/mo
Unmetered 1 Gbps€129/moprice on request
Unmetered 10 Gbps price on request
10 Gbps port €25/mo
BGP session, your own ASN €15/mo
Announcing your prefix from our ASN, per prefix €15/mo
BGP setup: LOA, route object and RPKI check, filters €49 one-off
Private VLAN €2/mo
Cross-connect, installation €299 one-off
Cross-connect €69/mo

Switches for racks: your own or rent ours

Switch 48 × 1 Gbps with 10 Gbps uplink, rented €49/mo
Switch 48 × 10 Gbps with 40 Gbps uplink, rented €199/mo
Management switch (IPMI and out-of-band), rented €29/mo
Managed switch: we configure and monitor it, per switch €19/mo
Second uplink on a separate switch, rack €49/mo
Management of your own network device €49/mo
  • Volume and premium differ in the quality of the uplinks. Premium is priced by the traffic you use, so you pay only for what you need.
  • 95th percentile: we measure every 5 minutes, set aside the busiest 5% of the month and bill the highest value that remains.
  • Every port runs at full port speed and is never oversold.
  • Devices always connect to our switch, port included. Need your own switch or firewall? Take a quarter rack.
  • Racks get one uplink. Bring your own switches (hand-off included, second uplink optional) or rent ours, configured and ready: one switch, or an MLAG pair with two uplinks for redundancy, plus a management switch if you want one. With a rented switch you get full access, or choose managed and we configure and monitor it while you request changes.

Switches: ours for devices, your choice for racks

A device needs nothing extra. A rack gets one uplink, and you decide what sits behind it.

Devices: always on our switch

Every device plan includes a port on our switch, so there is nothing to buy or configure. Need your own switch or firewall in front of your servers? Then a quarter rack is the right size.

Racks: your own switches

We hand the uplink over to your switch, included. A second uplink for redundancy is €49/mo. We never touch your configuration unless you ask us to manage the device (€49/mo).

Racks: rent ours

Configured and ready: 48 × 1 Gbps with a 10 Gbps uplink (€49/mo) or 48 × 10 Gbps with a 40 Gbps uplink (€199/mo); two as a redundant MLAG pair with two uplinks; a management switch for €29/mo. Full access included, or managed for €19/mo per switch — we configure and monitor, you request changes.

Cross-connects

A direct cable to another party in the facility: €299 once to install and €69/mo.

Redundancy is your choice

A second power feed and a second uplink are options per device or per rack. They are not in the from-price, so you pay for them only when you need them.

DeviceRack
Second power feed (A+B)€5/mo€59/mo
Second uplink on a separate switch€9/mo€49/mo
  • Redundancy is never included: you add it per device or per rack.

IP addresses

IPv6 and your own address space are included. Extra IPv4 addresses and blocks are there when you need them, at a small monthly price.

Extra IPv4 address €2.50/mo
IPv4 block /29 €15/mo
IPv4 block /28 €28/mo
IPv4 block /27 €48/mo
IPv4 block /24 price on request
  • IPv6 /64 is included, and so are your own addresses routed to your device or rack. Announcing them over BGP is paid: a BGP session with your own ASN, or an announcement from our ASN per prefix, plus a one-off BGP setup. Devices take up to 4 extra IPv4 addresses.

Redundant

Transport to Nikhef and Equinix AM5

Peering

Private and public peering

100%

Port Speed, Never Oversold

1 Tbit/s+

Network capacity

Network features

The parts of the network that stay the same on volume and premium.

Private and public peering

Broad peering arrangements for short, low-latency paths to major networks.

Redundant transport

Two independent paths connect our datacenter to Nikhef and Equinix AM5. If one fails, the other carries your traffic.

Full BGP table

Announce your own IP space over a BGP session with the full table from our upstream providers.

Basic DDoS filtering

Always-on detection with basic filtering is part of every colocation.

IPv6 included

Every colocation gets an IPv6 /64; extra IPv4 addresses are a small monthly line.

Never oversold

Port speed is never limited and capacity is never sold twice.

Network topology

Redundant transport from our datacenter to Nikhef and Equinix AM5, out to transit and peering. If one path fails, the other carries your traffic.

Two independent paths: if one fails, the other carries your traffic.

Questions about the network

What is the difference between volume and premium?
The quality of the uplinks. Volume uses cost-efficient transit and peering and includes traffic. Premium adds more and better connections and lower latency, and is priced by use: per TB for a device, per committed Mbps for a rack. Both run at full port speed.
What does the 95th percentile mean?
It is how a commit in Mbps is measured. We sample your traffic every 5 minutes, set aside the busiest 5% of the month and bill the highest value that remains. Ports are never limited or oversold; a short burst does not raise your bill.
Can I bring my own IP addresses?
Yes. We support BGP sessions for €15/mo and can announce your own provider-independent address space. You receive the full table from our upstream providers.
Can I get a 10 Gbps connection?
Yes. A 10 Gbps port is €25/mo on top of your plan. Unmetered 10 Gbps is available on request.
Is unmetered traffic available?
Unmetered 1 Gbps on the volume network is €129/mo. Unmetered premium is on request.
Is DDoS protection included?
Basic always-on detection and filtering is included with every colocation. Advanced scrubbing is not part of the standard offer; ask us if you need it.
Which upstream providers and peering do you use?
Multiple upstream transit providers, plus private and public peering, reached over redundant transport to Nikhef and Equinix AM5. Details are available on request.
Can I bring my own switch for a device?
No — devices always connect to our switch, which keeps the plan simple and the port included. If you want your own switch, router or firewall, take a quarter rack: one uplink, and behind it your own equipment or switches rented from us.

Questions about our network?

Ask for technical details or a test connection, or configure your setup and see the monthly total.

Talk to us